FRP Water Based Adhesive Recommended For Installing FRP Panels
SKU: 608644
$26.45 /each
Mohler Lumber & Hardware
In Stock
In-Store Pick-Up
Delivery Available
Description
The FRP Water Based Adhesive is designed for bonding fiber-reinforced plastic (FRP) panels to various porous surfaces. It has a working time of 20 minutes at 70°F and is effective in service temperatures ranging from 0°F to 120°F. Proper surface preparation is essential, requiring surfaces to be dry and free of contaminants. Cleanup is manageable with water while the adhesive is wet, or with a water/acetone/vinegar mixture if dried.
- Use on porous surfaces including gypsum board.
- Covers roughly 50 square feet per gallon.
- Ideal for demanding commercial and industrial applications.
- Formulated for bonding FRP panels to a wide range of surfaces.
Product Specifications
Application | Cut and pre-fit all panels. Lay fiberglass panels flat and let them acclimate to room temperature 24 hours before installing. Note: Do not use when temperature, adhesive or materials are below 50°F. Spread adhesive over entire back of panel, using a V-notch trowel with notches 3/16” wide x 1/4” deep. |
Application Temperature | Over 50°F and below 90°F for adhesive and substrates. |
Cleanup | Tools and adhesive may be cleaned with water while the adhesive is wet. If dried, tools and adhesive may be cleaned with water/acetone/vinegar mixture. Follow solvent vendor’s precautions. |
Limitations | Do not bond two non-porous substrates together such as FRP, metal, plastic, foam board, sealed concrete, fiberglass face or mold resistant gypsum wallboard or any other non-porous surfaces. |
Prep | Surfaces must be dry and free of any material that may deter adhesion, including severe and thick amounts of drywall joint compound. Patch holes and depressions and remove any bumps or high spots, dust, oil, and grease. Concrete surfaces must be well cured and completely dry. |
Recommended For | Installing FRP (fiber-reinforced plastic), plastic laminate, wainscoting and other wall coverings over many common porous surfaces. |
Service Temperature Range | 0°F to 120°F |
Working Time | 20 minutes at 70°F. |
